Bingo Plus stock

Win7 system one-click recovery: simple and Bingo Plus stockfast operation In the process of daily use of the computer, careless operation or virus invasion and other reasons may cause system crash, causing inconvenience to users. If important files and data are not backed up, the loss will be immeasurable. The one-click recovery function of the Win7 system can help users quickly restore the system to its previous state and reduce losses. This article will introduce in detail how to use the one-click recovery function of the Win7 system. I. Introduction to the function of one-click recovery of Win7 system Win7 system One-click recovery function is an important function launched by Microsoft in 2010. It can quickly restore the computer system to the preset restore point, so that users can quickly and conveniently repair the system in case of operating errors or system errors.Win7 system one-click recovery is composed of system restoration and WinRE. System restoration is a built-in function of the system, which restores the computer to its previous state through restore points. WinRE is composed of the recovery environment pre-installed in Win7, which provides a series of fault detection and repair functions. II. Turn on the one-click recovery function of the Win7 system. Before using the one-click recovery of the Win7 system, you need to turn on the recovery function. 1. Double-click the "Start" icon in the lower left corner, enter "Create System Restore Point" in the search bar, and enter.2. In the pop-up "System Properties", click the "System Protection" tab, select the hard disk and disk protection scope that need to be restored, and then click the "Create" button. 3. After creating the restore point, click the "OK" button. If you want to turn off the system restore function, please click the "Disable System Protection" button on the same interface.III. Use the one-click recovery function of the Win7 system. When the system crashes, operation errors or virus invasion, etc., when you need to use the one-click recovery function of the Win7 system, you only need a few simple steps to complete the recovery. 1. Restart the computer and enter the WinRE environment: Users can start the advanced boot option by clicking the F8 key many times, select "Repair Your Computer" in the boot options or select "System Recovery Options" through the Windows 7 system installation disk 2. Select "System Restore": On the WinRE interface, click "System Restore" and select the restore point to be restored. 3. Start system restoration: After the restoration point selection is completed, click the "Next" button and wait for the restoration to complete. IV. Precautions when using Win7 system one-click recovery When using the Win7 system one-click recovery function, you need to pay attention to the following points: 1.Data backup: Before manipulating the Windows system, it is recommended to back up the required important data to an external hard disk or USB flash drive to prevent the data from being deleted by mistake when restoring the system. Two. Recovery point creation: In order to create recovery points as up-to-date as possible, it is recommended that users create them manually once a week. 3. Computer restart: After using the recovery function, you need to restart the computer to make it work normally. Four. System version: The one-click recovery function of Win7 system is only applicable to the Windows 7 operating system, and users of other systems cannot use this function. In a word, the one-click recovery function of Win7 system is a very good way to solve system problems. Without professional knowledge, the computer system can be repaired with a simple operation, which saves users' time and effort to a large extent. When using the computer on a daily basis, you need to do your best.It is possible to set the system to automatically create recovery points and back up important files and data regularly to avoid unnecessary trouble when problems occur.

Contact Us
Phone：020-83484662